Beadboard Paneling Installation

You have measured and ordered your beadboard paneling from Design the Space.  It has been delivered. Now what? Here are some easy to follow steps that will have your beadboard paneling up and your room completely transformed.

First, use a pry bar to carefully remove existing moldings and any protruding surface materials. Also remove and save any window trim that will be in the way. The moldings will be replaced over the beadboard in the finished project.  Beadboard may be installed over drywall or old plaster providing these materials are solidly attached to the wall framing.  Turn off the electricity to any receptacles where the beadboard will be installed.

Measure, Mark and Cut the Beadboard.  Use a stud sensor to locate and mark the wall framing. Plan the installation to start at a left-side corner and work outward across the wall to the right.  Measure and cut the beadboard panels with a circular saw to the required height and width, if necessary.  Also carefully measure and mark any openings for electrical boxes.

Install the Beadboard.  Install the panels to the wall studs with finishing nails or a pneumatic nailer.  Adhesive may be used to fasten panels to a smooth, well-adhered surface. On the back of each panel, place a 1/4" bead of adhesive about 1" from the edges of the panel. Press the panel firmly onto the wall, and add nails at approximately 12” intervals to hold it in place while the adhesive dries.  Replace wall, floor and window moldings, rewire the electrical fixtures and reinstall them in their boxes.

These easy to follow instructions will ensure a smooth installation process of your beadboard paneling.  If any questions arise in the process, feel free to contact us.  Design the Space prides ourselves on our customer service.